wire rope electric hoist installation method Wire rope electric hoist is commonly used in industrial and mining enterprises, railway, port, warehouse of hoisting equipment, when installation should pay attention to the following five: 1. The steel wire rope electric hoist arrived at the installation site, should be carefully check is damaged in transit, and so on and so forth. 2. In order to adapt to the different use of h beam orbit, when installed in the gasket to adjust the operation mechanism of the width of the wheelset, adjust should keep the wheel rim and h beam profile with C = 4 ~ 5 mm per side clearance. 3. The steel wire rope electric hoist rail should be installed on both ends of stop pin and with elastic buffer device, in order to prevent the gourd derailment or collision damage the body. 4. In terms of or in connection of the h beam beam on the ground, available 30 4 ~ 5 mm is not less than 25 was bare copper wire or section of the metal conductor. 5. All electrical equipment after the installation, all electric circuit control circuit to ground insulation resistance should not be less than 1000 Ω per v working voltage.