Home > wire rope sling > Sling eye end plug connection cable
Sling eye end plug connection cable
2013-12-27 by xiugai
Sling eye end plug connection cable, plug length should not be less than 20 times the diameter of the wire rope and shall not be less than 300 mm, and should satisfy: plug connection strength should not be less than 70% of the rope minimum breaking force; Splice line should be taut, protruding part should be smooth level off, should be set aside at the end of the splice appropriate length (about 15 mm), fastened with wire, bend length should comply with the technical requirements. Sling the rope rope clamp fixed connection end of eye, shall not be used for assembly line, and should satisfy: rope clamp should comply with the technical regulations; Holder to pressure at the side of the wire rope work long hair, and in accordance with the provisions, torque tighten (rope get squashed 1/4 - a third diameter), and the connection strength should not be less than 80% of the strength of wire rope itself; Rope clip number (not less than three), spacing (about 5 to 6 times the diameter of wire rope) should comply with the technical regulations: the last rope clip from wire rope head should not be less than 140 mm. Sling end metal casing to suppress the grommet should satisfy: suppress connection strength shall not be less than the line the minimum breaking force; Ring sling each side must be suppressed two metal casing, and the inside of the spacing for sleeve length at least three times; On both ends of the sling metal casing inside minimum distance shall not be less than 10 times the diameter of the wire rope; Lead alloy joints should comply with the regulations of GB6946. Insert ring sling the smallest circumference of succession, the should not be less than 96 times the diameter of wire rope sling; Used in eye smooth round pin diameter or hook is 3 times of the width of the largest, and splice connection line hole inside length, should be at least 10 times the diameter of the wire rope accordingly. Pressed metal sleeve line hole inside length should be at least 15 times the diameter of the wire rope accordingly. Must be made by the whole rope sling, can not have joint in the middle.
   keywords:    wire rope sling